For the Highest Signal Density
The sensor/actuator terminal blocks feature several potential levels and one signal level.
The potential levels are for power supply and, if necessary, sensor grounding; the signal level transmits switching signals from two sensors or to the actuators.
A single terminal block housing accommodates two interconnected potential terminals with doubled spacing on the lower levels and two independent signal pathways with single spacing of 3.5 mm on the upper levels.
Range of Multifunctional Jumpers
Commoning Potential Levels
On the potential levels, standard jumpers can be used for commoning with no pole number limitation. Each terminal block has two connected clamping units and thus two connected jumper slots. This allows any number of terminal blocks to be commoned in just one jumper slot using jumpers with even pole numbers.
Commoning Signal Level
Two jumper slots are available on the signal level for commoning with standard jumpers. This level features two independent signal pathways. Terminal block versions with an LED have only one open jumper slot for testing or commoning.
For sensor/actuator terminal blocks without ground connection to the DIN-rail, the ground connection can also be performed economically by commoning to the terminal block with a ground foot (e.g., via the supply terminal block).
Orange supply terminal blocks with the same profile can be placed anywhere within an assembly. They are available in cross sections up to 4 mm². Power supply can be performed either via center feed or ring feed configuration.
The Fastest Marking System
TOPJOB® S Sensor/Actuator Terminal Blocks can be marked in multiple ways. Marking strips (2009-110) offer the fastest and easiest possibility. Multi-line marking simplifies the labeling of a terminal block’s function, allowing individual signals and groups to be marked simultaneously.
Marking using WMB markers (3.5 mm) is also possible. They are available as WMB Inline markers on a reel (2009-113) and as WMB marking cards (793-35xx).
TOPJOB® S Sensor/Actuator Terminal Blocks can be marked on the top and on the side, without covering the jumper slot.
A pivoting marker carrier (2000-121) can be snapped in as a retrofit for additional marking levels.
LED, Wiring and Marking in Plain View
TOPJOB® S Sensor/Actuator Terminal Blocks provide a fast overview – even when wired. Both a center LED, as well as commoning and marking on the signal level quickly tell you what you need to know.
For the very first time, sensor/actuator wiring is pluggable between terminal box and switch cabinet thanks to the newest additions of WAGO’s TOPJOB® S terminal block family! Both power supply and all signal paths can be combined into one single pluggable connector within a terminal box. Systems can be modularized via pre-assembled connectors.
Have any questions?
Please call us.
Tel.: +49 571-887-0